CW ID after 73: Check to send your call sign in CW after sending 73.You can prevent this from happening by selecting this option. If this happens, you can continue to inadvertently send the same message repeatedly. Runaway Tx watchdog: Occasionally, due to operator distraction, the next transmission in the series for making a minimally valid QSO will not be selected by the user.If you select this option, once you send your 73 message, WSJT-X will disable its transmit cycle. After sending your final message, such as K1ABC G0XYZ 73, it is possible to send this message again because Enable Tx is still activated. Disable Tx after sending 73: In a normal QSO sequence, the operator selects the relevant messages to send.By selecting this option, you are able to set WSJT-X to transmit by double clicking on a decoded message. However, many forget this and attempt a QSO by double clicking on a decoded message, which does not activate the radio. This default mode prevents undue transmissions. Double-click on call sets Tx enable: The default operating procedure in WSJT-X is to select the Enable Tx button in the user control window to begin a QSO.With this option enabled, WSJT-X tracks the station’s frequency but does not send any commands to the station in order to control the frequency/mode/spilt status, thereby not disrupting a currently ongoing QSO. ![]() If you prefer WSJT-X not to take over your station upon startup (which would be useful if you were already in the middle of a QSO and just warming up the program for later use) then select this option.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |